Ricky

CUAV Nora transplant on my Octo

Finally Spent some time tuning my Nora power Octo. Ran through a .06 and a .08 AT.
It’s amazing how stable this Octo is.

NEO 3 GNSS UAV Navigation Modules

NEO 3 uses a hardware design similar to NEO V2, and upgrades the GNSS navigation module to the M9N module that supports the four mainstream satellite systems of Beidou, GPS, Galileo and Glonass. The positioning accuracy has been significantly improved. It is a high Cost-effective unmanned system positioning and navigation module. It integrates compass, barometer, flight controller status light, buzzer, and safety switch in one; it has the characteristics of high sensitivity and strong anti-interference.

NEO 3 Pro GNSS UAV Module

NEO continues the hardware design of NEO V2, upgrade the GNSS module to Ublox NEO M9N, supports Beidou, Galileo, Glonas and GPS receive at the same time, and the horizontal positioning accuracy is up to 0.7M. Integrated with safety switch, buzzer, RGB light.

XunWing X4 Integrated System

CUAV’s newly launched Quacopter Integrated System is equipped with CUAV’s CUAVCloud system, which can transmit real-time high-definition video at unlimited distances.

X7/X7 Pro autopilot

X7&X7 Pro is an advanced autopilot launched in May 2020; it uses a higher performance STM32H7 series processor than the PX4 previous-generation flight controller (FMUv5), and integrates high-precision industrial-grade sensors and ultra-low temperature drift sensors. The first generation flight controller has better performance, more stable and reliable

Nora Autopilot

Nora is an advanced autopilot launched in May 2020; it uses a higher performance STM32H7 series processor than the PX4 previous-generation flight controller (FMUv5), and integrates high-precision industrial-grade sensors and ultra-low temperature drift sensors. The first generation flight controller has better performance, more stable and reliable

CAN PDB multifunctional Autopilot baseboard

CAN PMU is a drone power management unit with a built-in STM32F4 processor and running the CUAV ITT algorithm. It can accurately measure the drone voltage and current in real time. It supports a maximum of 6-62V voltage and 110A current and can output 5.4V 5A. (Maximum instantaneous 8A / 120s, constant 5A) Powers the flight controller, uses CAN bus communication, supports standard UAV CAN protocol, and each PMU unit is factory calibrated to ensure good consistency and high accuracy.